Trade Show Displays

Description
Set Up Instructions
Reviews (0)

SnapLock Laminate Floor Tiles

Product Description:

Made of high-impact copolymer with a durable laminate top surface
Patented multipurpose portable floor system designed to give you a clean surface
Can be used on any hard indoor or outdoor surface – Waterproof!
Easy to install. Simply snap together to make any size dance & event floor
Easy to clean and low maintenance
MADE IN THE USA

PowerLock™ Technology:
This patented positive interlocking system creates the most advanced and durable floors in the industry. Installation is a Snap! – No tools, no screws, and no finicky cam locks.

Engineered to withstand the unique demands of the rental floor, special event and hospitality industries
PowerLocks handle extreme loads (up to 25,000 pounds!) and keep panels securely locked together during your special events
Mulch-patented “Step-N-Snap” design makes these portable floors the easiest to install and most reliable portable floors on the market

SnapLock® Superstructure:

NoWalk™ technology – Over 840 support posts per square foot ensure your SnapLock floor stays put through the entire event
Self-draining design keeps your event high and dry – up to half an inch of water can flow freely under your special event flooring
Engineered to handle rolling loads up to 25,000 lbs

Step 1

Start by laying your first panel on any corner. The loops should be pointed in the direction you want to add panels.

Step 2

The panels have 2 sides with female loops, and 2 sides with male pegs.

There are two parts to the SnapLock locking system: Loop & Peg
The image shown above is for demonstration purposes
(Bottom of tile shown)

Step 3

Place the next panel so that the pegs line up over the loops.

Step 4

Gently step on each panel. You will hear and feel it snap into place. Repeat these steps until your flooring is complete. That’s all there is to it!

Tips

Always begin the installation in one corner, pointing the female loops in the directions that additional tiles are to be added. See animation below.

Correct

All tiles on any given installation should ALWAYS HAVE THE FEMALE LOOPS GOING IN THE SAME DIRECTION.

Incorrect

CAUTION: If you inadvertently rotate a tile 90° it will snap into place but you will not be able to complete the installation properly.

Edge / Corner Pieces

When finished connecting tiles, it is time to add the corners & edges to the sides. Use male or female depending on if the particular side is loop or peg.