Assembling Hyperlite is quick and easy.

First, install the bottom trusses between the lower half of the uprights.
The bottom of the bottom connection should be flush to the bottom of the extrusion.
Both should be on the floor with the truss 1/2” off the floor.

Next, insert the  extrusion connector into the top of each upright and then slide the top half of the upright over the connector.
Insure all the channels are properly aligned and tighten the screws.

Finally, install the top trusses. The top bracket has a bend at the top so the truss will be flush to the top of the upright.
Tighten the wingnuts and you’re ready to install your graphics!