TOP
Tops shall be constructed of solid, 47 lb., industrial grade
particleboard, surfaced with high pressure plastic laminate and shall be
backed with a phenolic sheet to prevent moisture penetration. Tops are
to be edged with vinyl T molding having a thickness of at least 1/8".
The T molding shall be secured against removal by the use of staples at
regular intervals on the underside of the table top.
TOP SUPPORT
FRAME
Table tops shall be supported by a formed steel channel frame at least
1-13/16" deep and of 16 gauge steel. The channel shall form a continuous
frame having square corners and welded joints. Frames shall be secured
to the table top with screws placed no greater than 10" apart.
LEG
ASSEMBLY
All leg assemblies shall be wishbone style having vertical load bearing
members of at least 1-1/16" diameter, 14 gauge, steel tubing. The upper,
horizontal tube on leg assemblies shall rotate within two, 16 gauge
steel saddle clips. Saddle clips shall be fastened to the table top
using a minimum of four screws each. Leg assemblies are to be capped at
the bottom with load bearing, high impact, plastic glides, secured with
spring steel internal grippers. No horizontal members shall be
positioned less than 12" from the floor to facilitate floor cleaning.
For stability, no wishbone style leg assembly shall have an offset in
the leg greater than five inches. Game tables and round tables 36" or
less in diameter are furnished with four independent folding legs of
1-1/16" diameter, 14 gauge steel tubing. |
